Cheap Flights from Akron canton Regional to Melbourne International

There are no direct flights from Akron canton Regional to Melbourne International being operated at present. Travel from Akron canton Regional to Melbourne International will require at least 1 stop over.

Flight Routes

You will find alternative routes from Akron canton Regional to Melbourne International that require 1 or more stops. On some occassions the timing may be more convenient or a quicker route. The table below shows some of the alternative route that are possible.

Alternative routes to Melbourne International

As a substitute, you will discover that Port Columbus International also give flights to Melbourne International which could be more fitting for you. Port Columbus International has around 10 flights a week though you will find the number of flights vary from month to month so check with the airline currier for the most up to date information.

If you wish to look at this alternative solution then remember Port Columbus International is around 159 kilometers (99 miles) from Akron canton Regional. Choosing this root would probably require you look at alternative travel arrangement or look at alternative airport parking where costs could vary from airport parking provided at Akron canton Regional. More information can be found at Flights from Port Columbus International to Melbourne International. Flights to Melbourne International are also available from Pittsburgh International; 10 flights a day depart from the airport.

Arriving at Melbourne International

If a friend or relative is collecting you at Melbourne International then make sure they visit our Melbourne International Airport Arrivals page that gives all needed about the flight arrival; planning the trip can useful should there a delay. Alternatively, if you choose to hire a car then visit our page which will give you the cheapest car hire quote from all companies based at Melbourne International.

When you arrive at Melbourne International keep in mind that the time zone is not the same as Akron canton Regional. Melbourne International is GMT +5.0 compared to GMT -5.0 at Akron canton Regional.

On leaving Melbourne International Airport Airport airport you will discover getting to your destination to be fairly easy. Melbourne International Airport Airport is situated around 2 miles (3 kilometers) from the center of Melbourne where a lot people will be heading. Melbourne has inhabitants of around 76,300 which it makes it a small city, so if you are looking for a place to stay it may be a bit trickier than other airports. It's advised you book before you leave.